This guide will explain to you how to install a new circulator pump as well as servicean existing pump.

• Spread your tools out in a safe place so that you can see everything. Also take the new circulator pump, flanges, gaskets and bolts out of the boxes and bags they came packaged in.
• Now that you have your tools ready you will want to isolate the area where the pump is being installed. What this means is that you will want to “valve off” the area. If you are just replacing a circulator then you should have isolation valves on each side of the flange.
• The first thing you should so if this is an existing pump is to shut of the power source and then you will now want to remove the wires that are connected to the motor, followed by recapping the ends with caps.